Part no.: 99 0201 00 07
RD24 Male cable connector, Contacts: 6+PE, 6.0-8.0 mm, unshielded, crimping (Crimp contacts must be ordered separately), IP67, PG 9
RD24, series 692, Power Connectors
This male cable connector with screw locking and a pin count of 6+PE is according to its protection class IP67 Dust-tight and has complete protection against contact and protection against temporary immersion. It can be used in areas with a pollution degree of 3. In places where contamination can occur that is conductive or can become conductive through condensation. With temperatures ranges of -40 °C/100 °C is this unshielded RD24 male cable connector designed for both severe cold and severe heat. Due to the qualified rated voltage of 250 V and the rated current of 10,0 A it is perfectly tuned for its field of application.
General features
MorelessPart no. | 99 0201 00 07 |
Connector design | Male cable connector |
Version | Connector pin straight |
Connector locking system | screw |
Termination | crimping (Crimp contacts must be ordered separately) |
Degree of protection |
IP67 IP65 with cable diameter 6-7 mm |
Cross-sectional area | click here for more info |
Cable outlet | 6.0-8.0 mm |
Temperature range from/to | -40 °C / 100 °C |
Mechanical operation | > 500 Mating cycles |
Weight (g) | 26.77 |
Customs tariff number | 85369010 |
Country of Origin | DE |
Electrical parameters
MorelessRated voltage | 250 V |
Rated impulse voltage | 4000 V |
Rated current | 10.0 A |
Insulation resistance | ≥ 1010 Ω |
Pollution degree | 3 |
Overvoltage category | III |
Insulating material group | III |
EMC compliance | unshielded |
Material
MorelessContact body material | PBT (UL94 V-0) |
Contact material | depending on crimp contact (accessory) |
REACH SVHC |
CAS 96-45-7 (Imidazolidine-2-thione) |
SCIP number | 3b30687d-7cc4-4a61-8b4a-53ec4d695894 |
Classifications
MorelesseCl@ss 11.1 | 27-44-01-02 |
ETIM 9.0 | EC002635 |
Declarations of conformity
MorelessLow Voltage Directive | 2014/35/EU (EN 60204-1:2018;EN 60529:1991) |
General Disclaim Notice
- The connector must not be plugged or unplugged under load. Non-observance and improper use can result in personal injury.
- The connectors have been developed for applications in plant engineering, control and electrical equipment construction. The user is responsible for checking whether the connectors can also be used in other areas of application.
- To protect against unintentional opening of the connector, the thread between the housing and the connector head must be secured with a suitable cyanoacrylate adhesive when used in circuits with voltages dangerous to the touch. This does not apply to connectors used in SELV and PELV circuits according to IEC 61140 (EN 61140, VDE 0140-1).
- Connectors which are used in circuits with voltages dangerous to the touch may only be installed and used by, or under the supervision of, persons with electrical engineering training, taking into account the applicable regulations and standards.
- The user must take suitable safety precautions to ensure that the connector cannot be accidentally disconnected.
- The plug connector is not suitable for mains voltages Please observe the pollution degree and the overvoltage category. For further information, please refer to the download center "Technical Information".
Downloads