Menu
Back
  1. Products
  2. Connectors for medical applications
  3. ELC
  4. Snap-In Male cable connector, Contacts: 12, 6.0-8.0 mm, unshielded, solder, IP54
Part no.: 99 1721 100 12

Snap-In Male cable connector, Contacts: 12, 6.0-8.0 mm, unshielded, solder, IP54

ELC, series 570, Connectors for medical applications
Compare product
Downloads
General features
Moreless
Part no. 99 1721 100 12
Connector design Male cable connector
Version Connector pin straight
Connector locking system snap-in
Termination solder
Degree of protection IP54
Cross-sectional area max. 0.25 mm² / AWG 24
Cable outlet 6.0-8.0 mm
Temperature range from/to -25 °C / 85 °C
Mechanical operation > 5000 Mating cycles
Weight (g) 17.22
Customs tariff number 85369010
Country of Origin DE
Rated voltage 150 V
Rated impulse voltage 1500 V
Rated current 2.0 A
Insulation resistance ≥ 1010 Ω
Pollution degree 2
Overvoltage category II
Insulating material group II
EMC compliance unshielded
Housing material PA
Contact body material PA
Contact material CuZn (brass)
Contact plating Au (gold)
REACH SVHC CAS 96-45-7 (Imidazolidine-2-thione)
CAS 7439-92-1 (Lead)
SCIP number e78329f6-d079-42bd-a7a7-9052190856e2
Low Voltage Directive 2014/35/EU (EN 60204-1:2018;EN 60529:1991)
RoHS Directive 2011/65/EU (EN 50581:2012)
General Disclaim Notice
  1. The connector must not be plugged or unplugged under load. Non-observance and improper use can result in personal injury.
  2. The connectors have been developed for applications in plant engineering, control and electrical equipment construction. The user is responsible for checking whether the connectors can also be used in other areas of application.
  3. To protect against unintentional opening of the connector, the thread between the housing and the connector head must be secured with a suitable cyanoacrylate adhesive when used in circuits with voltages dangerous to the touch. This does not apply to connectors used in SELV and PELV circuits according to IEC 61140 (EN 61140, VDE 0140-1).
  4. Connectors which are used in circuits with voltages dangerous to the touch may only be installed and used by, or under the supervision of, persons with electrical engineering training, taking into account the applicable regulations and standards.
  5. The user must take suitable safety precautions to ensure that the connector cannot be accidentally disconnected.
  6. Plug connectors with enclosure protection IP67 and IP68 are not suitable for use under water. When used outdoors, the plug connectors must be protected separately against corrosion. For further information on the IP protection classes, please refer to the "Technical Information" download centre.
  7. The plug connector is not suitable for mains voltages Please observe the pollution degree and the overvoltage category. For further information, please refer to the download center "Technical Information".
  8. To lock the cable connector to the device connector, we recommend tightening the threaded ring to 1 Nm. A suitable torque wrench is available as an accessory (order no. 07 0082 000).
ELC
99 1721 100 12